Rechercher des projets européens

6 projets européens trouvés

Recherche sur 125080 projets européens

 TERMINÉ 

Investigation of Bird Strike criteria for Natural Laminar Flow wings (BirdStrike)

Date du début: 1 janv. 2013, Date de fin: 30 juin 2016,

The BirdStrike project aims to establish a validated bird strike analysis capability, which enables the SFWA partners to simulate bird impact on a CFRP leading edge for a NLF wing. This will be achieved by setting up a combined program of test and analysis to determine the extent of damage and criteria to be applied to analyses of leading edge panels for NLF wings.The main scientific and technical ...
Voir le projet

 5

 TERMINÉ 

Cost Effective Reinforcement of Fastener Areas in Composites (CERFAC)

Date du début: 1 oct. 2010, Date de fin: 31 déc. 2014,

"CERFAC’s major challenge is the design and manufacturing of strong and cost-efficient joints for high performance CFRP aero-structures.In particular, transfer of distributed loading along rivets lines in the assembly of flat or curved thin-walled stiffened panels, and introduction of concentrated loads for connecting lugs with thicker laminates are special & frequent problems. Hence, CERFAC focus ...
Voir le projet

 15

 TERMINÉ 

Smart Aircraft in Emergency Situations (SMAES)

Date du début: 1 févr. 2011, Date de fin: 31 oct. 2014,

"Ditching analysis is requested for large transport aircraft by EASA. The respective requirements are specified under § ‘’CS 25.801 Ditching’’. They are primarily devoted to a minimisation of risks for immediate injuries and the provision of fair chances for an evacuation. A significant part of average air travel is over water and historically a planned or unplanned water-landing event occurs gros ...
Voir le projet

 16

 TERMINÉ 

Innovative Manufacturing of complex Ti sheet components (INMA)

Date du début: 1 sept. 2010, Date de fin: 30 juin 2014,

"The INMA project aims at developing an intelligent knowledge-based (KB) flexible manufacturing technology for titanium shaping that will lead to drastically reduce current aircraft development costs incurred by the fabrication of complex titanium sheet components with a minimal environmental impact. In particular, this project aims at strengthening European aircraft industry competitiveness, by t ...
Voir le projet

 11

 TERMINÉ 
Main aim of the project is the development of a complete, integrated process chain for the cost effective serial production of various aerospace CFRP stiffener profiles. The production is foreseen in the two steps: Preform manufacturing and infiltration / curing. The project will focus on complex profile geometries with variable cross sections, single or multiple curvature and integrated load int ...
Voir le projet

 20

 TERMINÉ 
"ADVISE is a prenormative project for experimental validation of simulations of dynamic events using full-field optical methods of deformation measurement. These powerful tools are used in evaluating the performance, reliability, and safety of primary structures and for validating their computational design. Optimised design of primary structures leads to lighter and more energy efficient produc ...
Voir le projet

 9