Rechercher des projets européens

18 projets européens trouvés

Recherche sur 125080 projets européens

 TERMINÉ 

Silicon Nitride Coatings for Improved Implant Function (LifeLongJoints)

Date du début: 1 avr. 2013, Date de fin: 31 mars 2018,

Articulating joint replacements represent a medical market exceeding €14 billion p.a. that is expected to rise as demographics reflect an ageing population. However, faster growth has been seen in the revision market, where prosthetic joints are replaced, than in primary interventions. The major cause of these revisions is that all joint replacements are prone to wear leading to loss of implant fu ...
Voir le projet

 16

 TERMINÉ 

ASCENT - Advanced Solid Cycles with Efficient Novel Technologies (ASCENT)

Date du début: 1 mars 2014, Date de fin: 28 févr. 2018,

"ASCENT will provide a robust proof-of-concept of three related high temperature processes; each will lead to a step-change in efficiency of carbon removal in three types of pre-combustion capture, producing the hydrogen needed for highly efficient low-carbon power production. The project brings together five small and medium enterprises preparing to launch these concepts with the support of leadi ...
Voir le projet

 18

 TERMINÉ 

Production and Reliability Oriented SOFC Cell and Stack Design (PROSOFC)

Date du début: 1 mai 2013, Date de fin: 31 oct. 2017,

This project aims at improving the robustness, manufacturability, efficiency and cost of SOLIDpower’s state-of-the-art SOFC stacks so as to reach market entry requirements. We propose a focused project addressing the key issues that have manifested themselves in the course of the ongoing product development efforts at SOLIDpower SA. The key issues are the mechanical robustness of solid oxide fuel ...
Voir le projet

 10

 TERMINÉ 

Delivering European Translational Information & Knowledge Management Services (ETRIKS)

Date du début: 1 oct. 2012, Date de fin: 30 sept. 2017,

Since its inception the IMI has funded over 30 public-private partnership projects. Many of these projects are centered upon data intensive translational research and are employing integrative analysis approaches to achieve their goals. Although a common KM platform for IMI projects was envisioned in the original IMI Strategic Research Agenda it has not yet been implemented. The lack of a common p ...
Voir le projet

 17

 TERMINÉ 

Graded Membranes for Energy Efficient New Generation Carbon Capture Process (GREEN-CC)

Date du début: 1 sept. 2013, Date de fin: 31 août 2017,

Major sources for human made CO2 emissions comprise the energy and the industrial sector including cement production. One of the most appropriate concepts to capture CO2 from such point sources is the oxyfuel combustion. The main energy demand for this method results from the O2 generation, which is usually done by air liquefaction. This energy demand can substantially be lowered using thermally i ...
Voir le projet

 14

 TERMINÉ 

Engine Breakthrough Components and Subsystems (E-BREAK)

Date du début: 1 oct. 2012, Date de fin: 31 mars 2017,

Future aero engines will need to be more efficient and contribute to the reduction on environmental impact of air transportation. They must reach some standards of performance by reducing emissions and creating some savings on operation costs.EIMG consortium has launched since several years some initiatives to develop future engines in the frame of the European Committee research programmes.Within ...
Voir le projet

 48

 TERMINÉ 

More Affordable Aircraft structure through eXtended, Integrated, and Mature nUmerical Sizing (MAAXIMUS)

Date du début: 1 avr. 2008, Date de fin: 30 sept. 2016,

Even though composite materials are more and more used in modern airframes, many significant improvements are still achievable. Firstly, the substitution of the assembly of many small composite parts by a single one-shot large part provides additional weight reduction. Secondly, the final assembly line process must be adapted to composite properties (lack of ductility, stiffness). Thirdly, if the ...
Voir le projet

 60

 TERMINÉ 

Graphene-Based Revolutions in ICT And Beyond (GRAPHENE)

Date du début: 1 oct. 2013, Date de fin: 31 mars 2016,

This Flagship aims to take graphene and related layered materials from a state of raw potential to a point where they can revolutionize multiple industries – from flexible, wearable and transparent electronics, to new energy applications and novel functional composites.Our main scientific and technological objectives in the different tiers of the value chain are to develop material technologies fo ...
Voir le projet

 154

 TERMINÉ 

Innovative and sustainable systems combining automatic milking and precision grazing (AUTOGRASSMILK)

Date du début: 1 janv. 2013, Date de fin: 31 déc. 2015,

AUTOGRASSMILK is a unique cooperation of SME associations representing close to 100,000 SME’s in Ireland, Denmark, The Netherlands, France, Belgium, and Sweden and the core agricultural RTD’s of these countries. AUTOGRASSMILK will analyze, develop, experiment and disseminate concepts for integrating grazing and automatic milking (AM) for dairy farms. By using a network of RTD’s, advisory connected ...
Voir le projet

 17

 TERMINÉ 

Component Performance-driven Solutions for Long-Term Efficiency Increase in Ultra Supercritical Power Plants - MACPLUS (MACPLUS)

Date du début: 1 janv. 2011, Date de fin: 30 juin 2015,

The intelligent and cost effective use of CCS technologies requires new strategies to increase the net efficiency of coal fired power plants. Among them, the most promising are summarised as below:- Increase working steam temperature and pressure in new USC power plants (350-370 bar, 700/720°C minimum), and hence increase the severity of fireside operating conditions,- Promote clean coal technolog ...
Voir le projet

 26

 TERMINÉ 

Improvements to Integrate High Pressure Alkaline Electrolysers for Electricity/H2 production from Renewable Energies to Balance the Grid (ELYGRID)

Date du début: 1 nov. 2011, Date de fin: 31 déc. 2014,

ELYGRID Project aims at contributing to the reduction of the total cost of hydrogen produced via electrolysis couple to Renewable Energy Sources, mainly wind turbines, and focusing on mega watt size electrolyzes (from 0,5 MW and up). The objectives are to improve the efficiency related to complete system by 20 % (10 % related to the stack, and 10 % electrical conversion) and to reduce costs by 25% ...
Voir le projet

 11

 TERMINÉ 

"Food Refrigeration Innovations for Safety, consumer Benefit, Environmental impact and Energy optimization along cold chain in Europe" (FRISBEE)

Date du début: 1 sept. 2010, Date de fin: 31 août 2014,

"The objective of the FRISBEE (Food Refrigeration Innovations for Safety, consumers’ Benefit, Environmental impact and Energy optimisation along the cold chain in Europe) project is to provide new tools, concepts and solutions for improving refrigeration technologies along the European food cold chain. At all stages the needs of consumer and European industry will be considered.The project will de ...
Voir le projet

 26

 TERMINÉ 

Low Emission Gas Turbine Technology for Hydrogen-rich Syngas (H2-IGCC)

Date du début: 1 nov. 2009, Date de fin: 30 avr. 2014,

The overall objective of this project is to provide and demonstrate technical solutions which will allow the use of state-of-the-art highly efficient, reliable gas turbines in the next generation of IGCC plants, suitable for combusting undiluted hydrogen-rich syngas derived from a pre-combustion CO2 capture process, with high fuel flexibility. The recognised challenge is to operate a stable and co ...
Voir le projet

 25

 TERMINÉ 

Solid Oxide Fuel Cells – Integrating Degradation Effects into Lifetime Prediction Models (SOFC-Life)

Date du début: 1 janv. 2011, Date de fin: 31 déc. 2013,

Long-term stable operation of Solid Oxide Fuel Cells (SOFC) is a basic requirement for introducing this technology to the stationary power market. Degradation phenomena limiting the lifetime can be divided into continuous (baseline) and incidental (transient) effects.This project is concerned with understanding the details of the major SOFC continuous degradation effects and developing models that ...
Voir le projet

 13

 TERMINÉ 

Developing a 1.2 kW air-to-air single-room heat pump unit for heating, ventilation, and air-conditioning (HEATPUMP)

Date du début: 1 août 2010, Date de fin: 30 nov. 2013,

We, EU HVAC industry AGs, represent the interests of more than 4,900 SME firms active in installation, commissioning and maintenance of heating, AC, and ventilation devices, are under threat from upcoming EC regulations (expected full compliance by 2015) to phase out such devices that are non-energy efficient, noisy, non-aesthetic and contribute to CO2 generation. These regulations are Directive 2 ...
Voir le projet

 15

 TERMINÉ 

Transmission system operation with large penetration of Wind and other renewable Electricity sources in Networks by means of innovative Tools and Integrated Energy Solutions (TWENTIES)

Date du début: 1 avr. 2010, Date de fin: 30 sept. 2013,

A group of 6 Transmission System Operators (Belgium, Denmark, France, Germany The Netherlands and Spain) with 2 generator companies, 5 manufacturers and research organisations, propose 6 demonstration projects to remove, in 3 years, several barriers which prevent the electric system from welcoming more wind electricity, and wind electricity from contributing more to the electric system. The full s ...
Voir le projet

 29

 TERMINÉ 

Development of postcombustion CO2 capture with CaO in a large testing facility: “CaOling” (CaOling)

Date du début: 1 déc. 2009, Date de fin: 31 mai 2013,

This project is aiming at the scaling-up of one of the most promising concepts for CO2 capture from coal power plants: postcombustion carbonate looping systems. This project focuses on the experimental pilot testing and scaling up of the process at scales in the 1 MW range. The 1 Mw carbonate looping pilot will be built in the Hunosa 50 Mwe CFB coal power plant of “La Pereda”, using a side stream ...
Voir le projet

 8

 TERMINÉ 

Enabling advanced pre-combustion capture techniques and plants (DECARBIT)

Date du début: 1 janv. 2008, Date de fin: 30 juin 2012,

DECARBit responds to the urgent need for further research and development in advanced pre-combustion capture techniques to substantially reduce emissions of greenhouse gases from fossil fuel power plants. The project will accelerate the technology development and contribute to the deployment of large scale carbon capture and storage (CCS) plants in line with the adopted European policies for emiss ...
Voir le projet

 18