6 projets européens trouvés
Recherche sur 125080 projets européens
TERMINÉ
Energy recovery in new and retrofitted heat pumps using a dedicated expander concept (EXP-HEAT)
Date du début: 1 déc. 2013, Date de fin: 31 mars 2017,
In vapour-compression cycles (VCC) and more specifically in heat pumps, mechanical work is supplied to the compressor for increasing the pressure of the evaporated refrigerant. Heat is rejected in the condenser (effective heating at heating mode), for the condensation of the refrigerant, which is then expanded in a throttle valve (no power produced), in order to decrease its pressure, resulting to ...
Voir le projet
8
Participants partenaires
TERMINÉ
Next Generation of Heat Pumps working with Natural fluids (NXTHPG)
Date du début: 1 déc. 2012, Date de fin: 30 nov. 2016,
The main objective of the project is the development of several reliable, safe, high efficiency and high capacity heat pumps working with the two most promising natural refrigerants: Hydrocarbons andCO2, together with a set of improved components and auxiliary devices adequate for the efficient and safe use of the two refrigerants.The project aims to reach a higher efficiency (10-20% SPF improveme ...
Voir le projet
15
Participants partenaires
TERMINÉ
Establishment of an integrated process chain for the cost-efficient manufacturing complex glass optics (CENTIMO)
Date du début: 1 oct. 2013, Date de fin: 30 sept. 2015,
Demand for complex yet low-cost glass optics is growing within the sectors of lighting technology, automotive engineering and in the areas of renewable energy. However European SMEs are continuously being confronted with the dual challenge arising from the trend towards increasingly complex geometries coupled with intense pressure on market prices.Still the state-of-the-art to manufacture complex ...
Voir le projet
6
Participants partenaires
TERMINÉ
A Novel Decision Support System for Intelligent Maintenance (IMAIN)
Date du début: 1 sept. 2012, Date de fin: 31 août 2015,
“iMain” is an European level research project aiming to develop a novel decision support system for predictive maintenance. To that end, a multi-layer solution integrating embedded information devices and artificial intelligence techniques for knowledge extraction and novel reliability & maintainability practices will be developed. The resulting solution will provide extended capabilities compared ...
Voir le projet
9
Participants partenaires
TERMINÉ
"Advanced Floor Grids for Green Regional A/C New Concept of Design, Manufacturing and Installation in Ground Full Scale Demo" (AFLOG)
Date du début: 5 nov. 2012, Date de fin: 4 avr. 2014,
"Pax Floor and Cargo Floor configuration based on a new manufacturing process here called Progressive Roll Forming (PRF) of ThermoPlastic Carbon Reinforced Polimers (TPCRP) is presented. The process basically applies to seat rails and longerons. Raw material flows into the manufacturing device continuosly; one or more plane sheets, are progressively heated, bended and compacted each other by roll ...
Voir le projet
1
Participant partenaire
TERMINÉ
Development of a Non-destructive Sensor to Determine Density Gradient of Ceramic Tiles During Pressing (Novapress)
Date du début: 1 mars 2010, Date de fin: 30 juin 2012,
The occurence of density gradients in ceramic tiles during pressing is believed to be the main cause of defects during processing. Problems such as differential shrinkage and warpage typically arise leading to losses or down-grading of final products. Density gradients are caused by poor die design, bad practice and/or unsuitable particulate materials, with the resultant poor flow ability impactin ...
Voir le projet