Rechercher des projets européens

15 projets européens trouvés

Recherche sur 125080 projets européens

 TERMINÉ 

Valorisation of biorefinery by-products leading to closed loop systems with improved economic and environmental performance (VALOR-PLUS)

Date du début: 1 déc. 2013, Date de fin: 30 nov. 2017,

The Valor-Plus supports the realisation of sustainable, economically viable closed loop integrated biorefineries through the development of new knowledge, (bio-)technologies and products that enable valorisation of key biorefinery by-products. The project comprises five key areas:• Pre-treatment and fractionation: development of a novel methodology for the controlled and selective breakdown, relea ...
Voir le projet

 14

 TERMINÉ 

Optical Infrared Co-ordination Network for Astronomy (OPTICON)

Date du début: 1 janv. 2013, Date de fin: 31 déc. 2016,

Optical-infrared astronomy in Europe is in a state of transition and opportunity, with the goal of a viable structured European scale community in sight. A strong astronomical community requires access to state of the art infrastructures (telescopes), equipped with the best possible instrumentation, and with that access being open to all on a basis of competitive excellence. Further, the community ...
Voir le projet

 26

 TERMINÉ 

New generation of protective coatings alternative to hard chrome (HARDALT)

Date du début: 1 déc. 2013, Date de fin: 30 nov. 2016,

The total annual estimated direct cost of corrosion, not including wear damage, in the worlds is estimated at about 3.1% of the world’s Gross Domestic Product (GDP). Protective coatings serve to prevent wear and corrosion and thus reduce the total loss from corrosion and wear. Hard chromium plating is one of the most widely used techniques for production of such coatings. However, hard chromium fa ...
Voir le projet

 12

 TERMINÉ 

Development of sustainable electrochemical corrosion protection systems for reinforced concrete structures (DOSECOPS)

Date du début: 1 juil. 2012, Date de fin: 30 juin 2016,

Corrosion of reinforcing steel in concrete structures is a worldwide problem and affects a large number of infrastructures. Two major causes connected to corrosion of reinforcing steel are the carbonation and chloride attack. Concrete carbonation produces a carbonated surface layer in which the pore solution pH value is depressed to near-neutral levels. A fall in pH to values below 10 at the steel ...
Voir le projet

 3

 TERMINÉ 

Advanced manufacturing processes for Low Cost Greener Li-Ion batteries (GREENLION)

Date du début: 1 nov. 2011, Date de fin: 31 oct. 2015,

GREENLION is a Large Scale Collaborative Project with the FP7 (topic GC.NMP.2011-1) leading to the manufacturing of greener and cheaper Li-Ion batteries for electric vehicle applications via the use of water soluble, fluorine-free, high thermally stable binders, which would eliminate the use of VOCs and reduce the cell assembly cost.GREENLION has 6 key objectives: (i) development of new act ...
Voir le projet

 19

 TERMINÉ 

Novel Nano-enabled Energy Efficient and Safe HVAC ducts and systems contributing to an healthier indoor environment (NANO-HVAC)

Date du début: 1 sept. 2012, Date de fin: 31 août 2015,

The NANO-HVAC project concept aims at developing an innovative approach for ducts insulation while introducing new cleaning and maintenance technologies, all enabled by cost-effective application of nanotechnology. The main concepts are:1. Safe, high insulating HVAC-ducts enabling minimization of heat/cool losses: cost-effective, safe and extremely thin insulating duct layers that can be applied ...
Voir le projet

 11

 TERMINÉ 

Multiscale Modeling of Chemical and Biochemical Systems (MULTIMOD)

Date du début: 15 déc. 2009, Date de fin: 14 déc. 2013,

"The MULTIMOD Training Network will have duration of 48 months and will bring together 8 academic research groups with 5 industrial partners from 8 European countries to undertake innovative research and scientific research training in “Multi-Scale Computational Modeling of Chemical and Biochemical Systems”. The network will provide unique cross- and multi-disciplinary training opportunities for 1 ...
Voir le projet

 13

 TERMINÉ 

Early Recognition, Monitoring and Integrated Management of Emerging, New Technology Related Risks (iNTeg-Risk)

Date du début: 1 déc. 2008, Date de fin: 31 mai 2013,

iNTeg-Risk is a large-scale integrating project aimed at improving the management of emerging risks in the innovative industry. This will be achieved by building a new risk management paradigm for emerging risks, which is a set of principles supported by a common language, commonly agreed tools & methods and Key Performance Indicators integrated into a single framework. As main impact, it will red ...
Voir le projet

 67

 TERMINÉ 

Optical Infrared Coordination Network for Astronomy (OPTICON)

Date du début: 1 janv. 2009, Date de fin: 31 déc. 2012,

"The Optical Infrared Coordination Network for astronomy brings together all the national and international agencies and organisations which fund, support, develop and operate Europe's facilities for optical and infrared astronomy, both night-time - callsical astronomy- and daytime - solar astronomy. Opticon provides a framework allowing joint action to improve the quality of Europe's infrastructu ...
Voir le projet

 22

 TERMINÉ 

Emission analysis. Tools required to perform the emission analysis and evaluation methodology (EMICOPTER)

Date du début: 1 déc. 2009, Date de fin: 30 nov. 2012,

"The project aims to define an effective procedure to determine pollutant emission from helicopter engines during different flying conditions. The basis strategy is to couple detailed kinetics, needed to determine those components which are present in a low or very low concentration, with detailed fluidynamics necessary to describe in an accurate way the thermal and fluid flow fields, which contro ...
Voir le projet

 1

 TERMINÉ 

CoeLux: the sky light reconstruction in artificial illumination by means of solid transparent nanocomposites (CoeLux)

Date du début: 1 déc. 2010, Date de fin: 30 nov. 2012,

The quality of artificial illumination is a major concern in modern society, where living conditions often deprive us of the comfort of natural light. The global replacement of incandescent with fluorescent or white-LED lighting, foreseen owing to energy-saving constrain, will represent impoverishment in terms of colour-rendering capacity, thus raising the problem to the level of health care. In a ...
Voir le projet

 9

 TERMINÉ 

valiDation of Radical Engine Architecture systeMs (DREAM)

Date du début: 1 févr. 2008, Date de fin: 31 janv. 2012,

"Since the publication of the ACARE goals, the commercial and political pressure to reduce CO2 has increased considerably. DREAM is the response of the aero-engine community to this pressure. The first major DREAM objective is to design, integrate and validate new engine concepts based on open rotor contra-rotating architectures to reduce fuel consumption and CO2 emissions 7% beyond the ACARE 2020 ...
Voir le projet

 46

 TERMINÉ 

Novel high-pressure water hydraulic equipment for application in the construction and mining sector (HYDRO-COAT)

Date du début: 1 oct. 2009, Date de fin: 30 sept. 2011,

"Hydraulic power transmission with oil as power transmission fluid is widely applied in industrial applications. The main consumer of hydraulic fluids are heavy duty hydraulic machines such surface and underground mining equipment, drilling rigs and earth-moving machines. Petroleum-based hydraulic fluids and lubricants are persistent and toxic. They need to be disposed at the end of life in order ...
Voir le projet

 9

 TERMINÉ 

Integrated synthesis and purification of single enantiomers (INTENANT)

Date du début: 1 juin 2008, Date de fin: 31 mai 2011,

Several industries have an increasing interest in improving their access to pure single enantiomers of biologically active substances. The latter often form the basis for valued added products relevant for, among others, the pharmaceutical, cosmetic, and food industries. Up to now there exist two generally rivalling concepts for producing pure enantiomers. One approach is based on developing and a ...
Voir le projet

 11

 TERMINÉ 

Innovation Community Como-Ticino per l'innovazione d'impresa

Date du début: 28 févr. 2009, Date de fin: 27 févr. 2011,

The project aims to promote the development and competitiveness of the cross-border territory Province of Como and the Canton Ticino, leveraging both technological innovation business as a primary tool for achieving the above objectives in developed countries and high labor costs, which are now Italy and Switzerland. In particular, the project aims to create a single, organic and sustainable c ...
Voir le projet

 6